View Full Version : Canted FSB reinstall??
Is it possible to get the front sight tower canted after reinstalling it or does it pretty much line itself up? The reason i ask is i recently had a rail installed and i had never fired the rifle before i had it installed....i took it out today and shot and it was around 6 inches to the right at 50 yards....i was able to drift the rear sight and get it sighted in, but every ar i have ever shot has been pretty close to center without having to adjust it....thanks
There a pin in the barrel extension and a notch in the upper receiver for that pin to slide into so the fsb alignment should not change much. The only thing that can cause misalignment is an over-torqued barrel nut.
Is it possible to get the front sight tower canted after reinstalling it or does it pretty much line itself up? The reason i ask is i recently had a rail installed and i had never fired the rifle before i had it installed....i took it out today and shot and it was around 6 inches to the right at 50 yards....i was able to drift the rear sight and get it sighted in, but every ar i have ever shot has been pretty close to center without having to adjust it....thanks
Yes it is. Typically the reason for this is because the pins were not driven back in all the way.
C4
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.