MUR build completed

[mtdawg169]

I just finished this tonight. Some of you probably saw the upper in Grant's MUR build thread. I added the last few parts to the upper & just finished the lower that will be it's new home. Only thing left to do is mount an optic.

On a side note, one thing I noticed immediately is how well the MUR finish matched my RRA lower, but also how well it fit. It is tight but has no slop & attaches much easier than my Sabre upper which is very tight. The DD Lite rails are very nice too. :D

Specs:
RRA Lower w/ 2 stage NM trigger
Vltor receiver extension
Magpul CTR stock
Vltor ambi receiver plate w/ HK sling loop
Magpul trigger guard
Tangodown Battlegrip

Upper build by G & R
Vltor MUR
Noveske 16" Recon 1/7 midlength bbl
KG coat black
DD 9.0 Lite rail
Vltor gas block
Young NM carrier
CMT MP tested bolt
Vortex FH
Std. CH w/ PRI big Latch
Troy Industries BUIS set


http://i75.photobucket.com/albums/i287/mtdawg169/MURside.jpg


http://i75.photobucket.com/albums/i287/mtdawg169/MURsideclose.jpg


http://i75.photobucket.com/albums/i287/mtdawg169/MUR1close.jpg


http://i75.photobucket.com/albums/i287/mtdawg169/MUR3.jpg

[Paulinski]

Awesome carabine. Congrats

[mtdawg169]

Awesome carabine. Congrats

Thanks bro. I've been working on it for a while. I have to say Thanks to Grant at G&R for putting together the upper, it is awesome. Weather permitting, I'll take it to the range this weekend.

[musashi666]

Wow, I was thinking of building a rig almost exactly like that one! You must have ESP or something!

What type of optics are you going to use?

[mtdawg169]

Well, i sorta wanted a double duty rig. I'll run an Eotech on a Larue mount & a low power (1-4X) scope. I'm undecided on the make so far. Probably a Leupold, also in a Larue SPR mount.

[C4IGrant]

Very nice! :D



C4