View Full Version : Help with toolmark ID's?
30 cal slut
09-26-11, 11:59
Is there a thread/database out their with toolmark ID's?
I recently came across an upper. It had a broken capital "A" by the carry handle and the letters "RI" in a circle on the FSB. Bolt carrier is unmarked as far as I can tell.
I'm stumped on the ID ... help?
The "broken A" is the symbol for Anchor-Harvey Forge. A "square" is Brass Aluminum Forging Enterprises. A combined "AF" is Alcoa Forge, if I remember correctly. A "bird head" is Cardinal Forge. A "key hole" is Cerro forge.
Never seen any info regarding the FSB markings.
Failure2Stop
09-26-11, 14:42
https://www.m4carbine.net/showthread.php?t=5357
It's mostly meaningless info. Forge markings don't assure you that final machining is right... or that mil spec parts were used, etc.
30 cal slut
09-26-11, 17:01
https://www.m4carbine.net/showthread.php?t=5357
Thank you. (I did a search for "tool markings" and came up empty).
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.