View Full Version : The pin migrating out for hinged trigger safety on the M&P 9
oddballmkg
10-03-11, 01:42
The pin is backing out on the left side of the trigger after about 300 rounds. I’m having to re-seat the pin after every range trip. The pistol has only has about 12,000 rounds though it. Does any body know if the pin a press fit or is it locked into place with a dent spring?
Thanks
The pin is backing out on the left side of the trigger after about 300 rounds. I’m having to re-seat the pin after every range trip. The pistol has only has about 12,000 rounds though it. Does any body know if the pin a press fit or is it locked into place with a dent spring?
Thanks
I've seen it before.
It's just an interference fit pin.
I slightly bend it and push it back in. It'll stay put then.
DON"T bend it too much.
It's an interference fit, as stated above.
A new trigger bar assembly is 15-18 bucks depending on where you get it from. I'd just get that and swap it in.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.