Is this a good value starter AR15 builder kit for lower?

[Texas42]

http://www.riflegear.com/p-806-riflegear-lower-receiver-builders-kit.aspx


Lower receiver magwell vise block
1/4" Clevis pin - For installation of front pivot pin.
1/16" Allen Key - For Magpul enhanced and MOE trigger guards.
RRA Stock wrench - For carbine, A2, and Magpul UBR.
1/8" roll pin starter punch
3/32" roll pin starter punch

$45

I'm fairly new to AR's, but I do have stripped lower around that I want to put some good innerds in. I don't have much in the way of tools lying around (apartment living), but I do have access to a vice.

Thanks
Chris

[sadmin]

Keep the castle nut wrench, leave the cannoli; that other stuff is luxury.
PM me your address and I will send you a castle nut wrench.

[Toyoland66]

The only tool in that kit that you really need is the castle nut wrench (stock wrench). The roll pin punches could be handy but aren't a necessity. Most people assembly a lower with a small hammer, vice grips, some tape, and a few punches.

But, if you have nothing in the way of tools, it's a decent start, and the only other thing you will need is a hammer.

Eta sadmin beat me to it, and that's a generous offer.

[Texas42]

Thank you very much. I'll send you PM.

Chris