View Full Version : Deleted
davidjinks
11-30-11, 06:41
………………………………………………….
No timing. Torque to spec.
No it doesn't need to be timed. It can inly screw in so much due to it's design. Just make sure that there is threadlocker on the screw that goes into the buttstock.
I just got done assembling a lower with an A2 stock. My question is:
Is there a specific way to "Time" the RE?
I've noticed a couple other A2 RE and the (For lack of better words) head of the RE (Wrench area) is always straight up and down.
Do they need to be that way?
It's torqued to ~38 ft. Lbs...
Sweet! Gunz is finally up at a decent hour! Now he'll be ready to shoot Saturday at 6am!! :)
davidjinks
11-30-11, 07:13
…………………………………….
Thanks guys!
I did not put thread locker on the stock screw. I'm assuming blue loctite???
Yeah. I use Vibra tite... which is RED, but not Permanent.
davidjinks
11-30-11, 12:04
……………………………………………………………………..
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.