KiraX105
12-10-11, 20:10
So I did some reading and took the opportunity to remove that sear block in the 6520. My rifle was one that had the 3 pins, 1 on either side of the receiver and a very small one at the bottom.
After cutting through the block and removing the block, the remaining pin material in the receiver walls was loose enough to come out as well. Now I have two very neat holes in both sides of the receiver above the selector switch.
So, does anyone know of a good aluminum epoxy to seal the parts that fell out and the receiver. Ultimately, I'm not too concerned about it as I have two other 6520s, but I would like to fix the cosmetics of this one.
Link to Flikr : http://www.flickr.com/photos/amccaughey317/sets/72157628363447433/
Backstory on this one, local fun store had a supply of LEO trades and picked them up at $500 each.
After cutting through the block and removing the block, the remaining pin material in the receiver walls was loose enough to come out as well. Now I have two very neat holes in both sides of the receiver above the selector switch.
So, does anyone know of a good aluminum epoxy to seal the parts that fell out and the receiver. Ultimately, I'm not too concerned about it as I have two other 6520s, but I would like to fix the cosmetics of this one.
Link to Flikr : http://www.flickr.com/photos/amccaughey317/sets/72157628363447433/
Backstory on this one, local fun store had a supply of LEO trades and picked them up at $500 each.