View Full Version : Any non-standard parts on Magpul lower?
I know it's hard to say for sure until they actually get released, but I'm wondering if I'll need anything other than the standard stuff to assemble a Magpul lower. I seem to remember seeing something about the bolt catch pin somewhere, but my search-fu is weak. Searching for bolt, catch, or pin on this site gets you nowhere... :D
I know it's hard to say for sure until they actually get released, but I'm wondering if I'll need anything other than the standard stuff to assemble a Magpul lower. I seem to remember seeing something about the bolt catch pin somewhere, but my search-fu is weak. Searching for bolt, catch, or pin on this site gets you nowhere... :D
I'm pretty confident in my answer, so I'll give it a shot.
There is no bolt catch rollpin, so that may be what you are thinking of. Its been replaced with a threaded bolt that is smooth where the bolt catch engages. This recesses and looks like a standard roll pin when viewed installed.
A standard LPK will be all you need to assemble your Magpul lower, you will end up with a few extra parts.
Thanks, Stickman. Will that part be included or is it something you can find anywhere?
ETA: I would also owe you a steak dinner if you can post up some more porn featuring that lower.... :D
Thanks, Stickman. Will that part be included or is it something you can find anywhere?
ETA: I would also owe you a steak dinner if you can post up some more porn featuring that lower.... :D
KNS pins are something that doesn't come with a standard lower parts kit, but are available through a variety of dealers.
If I get the chance, I'll take you up on the steak dinner, or grab a beer if we ever meet. Just in case we don't, I'll open another beer right now.
I've got some Magpul lower pictures that I think would make decent wallpaper, but it may be a little while until those come up, hopefully this will tie you over.
http://stickman.rainierarms.com/galleries/Magpul%20II/IMG_8636%201028%20Stick.jpg
http://stickman.rainierarms.com/galleries/Magpul%20II/IMG_8643%201028%20Stick.jpg
Thanks again, Stickman, and if anybody needs me, I'll be locked in my bedroom..... :eek: :eek:
Stick's got a 20 round PMag? When do those suckers come out????
Stick's got a 20 round PMag? When do those suckers come out????
I think we are still a little ways out. I can say that so far the 20 round PMAGs have been flawless under regular and suppressed shooting. I have done zero FA firing with them as of right now.
Stick's got a ranger plate for his 30 rd too :D
Only one Ranger Plate, and I have to change it back and forth between 20 and 30 round PMAGS just to keep you guys plied with pictures.... :) I hope you feel my pain over here.
The lowers are machined with the Norgon Ambi-Catch in mind (not pictured in Stick's photos). There may be a few other changes - I don't know what final configuration has been decided on, or if that information has been released. I know there was a long thread on TOS about the lower, but I can't seem to find it right now. If you want, I'll post the assembly instructions here as soon as they're complete and the lowers are ready to ship.
Assembly instructions would be much appreciated! :D
Assembly instructions would be much appreciated! :D
Workin' on it!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.