PDA

View Full Version : Gunsmithing Questoins???



lil'Zeus
01-12-12, 14:28
After searching and reading various threads on here, Adco Firearms is highly reputable for the work they do.

I have assembled my parts; barrel, FSB, BC1.5, hand guard cap and barrel nut to be sent off. I am wanting the FSB aligned properly and tapper pinned, Bayo lug and sling mount ground off and the BC 1.5 pinned and welded.

Before I send this off is their any other great people who offer these services that I should consider? Or am I heading down the right road? I have already spent more to build a more basic rifle than what I could have had if my objectives were different, no sense in cutting the last corner!

Thanks in advance for you suggestions.
Shane

Hmac
01-12-12, 15:27
I've had Adco install an FSB and barrel nut on a BCM barrel I sent them. I've also had Ranier do the same kind of work before. In both cases, it worked out very well. For the future, I have also become intrigued by AR15 Barrels ( http://ar15barrels.com/services.shtml ). They have a good reputation AFAIK and I think their prices are a little lower.

SteveL
01-12-12, 15:46
I've seen people report that Rainier Arms does good work, as well as Robb Jensen at Virginia Arms.

http://www.rainierarms.com/?page=shop%2Fbrowse&category=gunsmithing

http://www.virginiaarms.com/

I'm sure you're aware Robb Jensen is a moderator here so you could send him a PM about the work you need done.

lil'Zeus
01-12-12, 22:24
Thanks for the suggestions guys! I appreciate it and certainly will look into it. I just want good quality work, and If I can get it out this week yet I'm not really concerned on timing either. I leave next week and will be on the road for work and won't need it back quickly.

Thanks again guys!
Shane