View Full Version : LWRC PSD 6.8 upper question.....
I have a Mk18 factory SBR in 10.3" , I was thinking about buying a second upper for it, and I really like the LWRC PSD in 6.8 SPC.
will that upper fit properly on the DD MK18 lower receiver?
.......... I am waiting MarkM................:eek:
Ok,
Lets not wind up markm now, shall we!
The PSD upper in 6.8 will fit fine. I have two shooting buddies who have them on their LWRC SBR's.
The only issue they have is finding low cost ammo to keep them fed.
Microalign
02-10-12, 08:04
Ok,
The only issue they have is finding low cost ammo to keep them fed.
Unless you are Mr. Moneybaggs, the only way to affordably shooting 6.5, 6.8, 300blk, or .308 is to reload. Reloading 6.8 will only cost you around $.20 a shot for training loads.
Unless you are Mr. Moneybaggs, the only way to affordably shooting 6.5, 6.8, 300blk, or .308 is to reload. Reloading 6.8 will only cost you around $.20 a shot for training loads.
They can afford it. I can't so I reload.
Where do you think I get all the free SSA/Hornady once fired 6.8 brass from? :D
Microalign
02-10-12, 08:23
They can afford it. I can't so I reload.
Where do you think I get all the free SSA/Hornady once fired 6.8 brass from? :D
Lol, that's some good friends to have. On the other hand, you might be considered a parasite. :D
Lol, that's some good friends to have. On the other hand, you might be considered a parasite. :D
They don't reload!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.