PRC-148 Radio, First Impressions and Initial Setup, and Follow on Setup on Chest Rig
Hey Turnkey... A couple of thoughts on trying to narrow it down if you cannot find another 6 pin PTT adapter.
1. It was difficult to tell, but is that locking washer inside the PTT headset flush with the base of the pin nubs?
2. Can you verify that the nubs are in the same position as the slots on the male 6 pin on the radio? Maybe you can hold it upside down next to it.
3. Take something a small tape measure or even a toothpick and measure the radio 6 pin and measure the headset 6 pin just to make sure that the headset is seating far enough down.
I think we can agree that it's likely not, but maybe this can help you narrow down the part that is defective. Or as it said try another PTT cable or headset. I looked for an extra I would mail you, but no joy on that.
I have seen in the past where a cable
Was rebuilt and that circular retaining clip was not pressed deep enough and it prevented locking on the radios. These were standard mil spec Army radios. I can go out to my shop and check your radio and headset measurements.
Sent from my iPhone using Tapatalk