It’s either that or my yo-yo when I am not actually doing something with my sorry ass life
Printable View
https://www.youtube.com/watch?v=BhA3vVyQifY
:laugh:
Solid 8/10, would have totally hid her in a closet then penned a fictional bestseller about it later.
So the person who can write this shit but still believe they have never done anything or useful or of merit is a hilarious contradiction.
Here is what you have done, you have seen. You have seen with real eyes. Mission Accomplished. Few people get to see what Roy Batty has seen.
No go drink a f'ing Mr. Pibb and think happy thoughts. Everyone wants a do over at some point, but you have to accept the fact that even with a do over and a master plan, you'd probably still f it all up to more or less the same degree as your current existence.
There is luck, talent and timing and you can only have direct control over one of the three. Life is vegas odds at best unless you were born fortunate and even then that is no kind of guarantee.
I think m4c pays FF to post something when the site is looking stagnant.
You say to yourself " Oh no. Not another lube thread.
Haven't heard from FF lately".
-Pivot pin installation will simply never be easy for me. I have been to Colt Armorer multiple times, built several ARs, and I simply cannot and will not ever be able to install a GD pivot pin without launching a detent, going into a fit of rage, cursing bitterly, denouncing the world, and screaming “THIS IS YOUR HOME. WHY DONT YOU WANT TO GO INTO YOUR HOME?! WHAT’S WRONG WITH YOUR HOME?!”
It just never gets easier. Ever. Some of you probably just miracle them into the lower. I just never will.
Sigh
I used a pencil on my first build for the pivit pin, what ever i did was easy, never had a issue. Some reason my dumb ass messes up the bolt catch pin. Cant seem to start something as simple as that. I always buy a few of those roll pins because i know i will butcher it. I only out a few together. but all of them had issues with that. I put a shit ton of painters tape so i can swing a full size hammer and not ding up the lower.