Printable View
I figured this is the most appropriate place to ask this.
I'm looking for something that holds maybe 4-6 CR2032 coin batteries. I've seen a few on etsy that are 3D printed but was looking for something that is a bit higher quality.
I have Storacell holders for AAA and CR123 batteries but unfortunately they don't make anything for the CR2032.
Sent from my SM-S908U using Tapatalk
3D prints are not often 'water tight' due to the layer structure.
Post heat treating can improve it.
I've been using clear packaging tape to make a 'sleeve' for 2023s. Any thoughts on that?
In not concerned about water resistance if I can put them in a zip lock, I think it would be fine.
Tape is an option, I just don't want the residue from the tape sticking.
Sent from my SM-S908U using Tapatalk
Best thing I've found so far are actually tiny Ziplocs. I have seen a spare battery holder that screws shut, uses an O-ring and attaches to a picatinny rail, but I can't remember where now. Struck me as bulkier than I would have liked, but I think it kind of goes with the territory of what it is.
ETA: Here it is:
https://m.media-amazon.com/images/I/...AC_SL1500_.jpg
https://www.amazon.com/Vortex-Optics.../dp/B081TNF36Z
This ia an old old thread ( https://www.m4carbine.net/showthread...rage-Case-Idea ) I did a few years ago that works great and is cheap BUT none of the pictures are available. Maybe my blabbing gives 1/2 an understanding to what I was trying to accomplish.
Just thought it might give you a general idea?
.
I use a couple of old contact lens cases. They only hold one on each side, but are water tight. I suppose you could paint them if the colors don’t suit.
This literally just launched:
https://thyrm.com/product/cellvault-5m/
Have an XL tube from them with 3xAAA for the muffs and 2032 for the aim point in it that works just fine at 50% of cost. Use 3M electricians tape to make sure nothing shorts out.
I have a ton of old contact lens cases and I never thought to check the fit.Quote:
Originally Posted by Rayd8
If the ones I have fit these batteries, I think that's all I need.
Sent from my SM-S908U using Tapatalk
That's some pretty cool stuff, lots of options tooQuote:
Originally Posted by Allen
I’m using old pill containers to store my CR2032s
I use a very small tackle box for fishing supplies. The pill bottle idea is great too.