If they would make a 10 or 10.5 rail again, I'd never use anything else.
Sent from my SM-G920V using Tapatalk
Printable View
The standard port 11.5 barrel shoots good as well. I was able to get my KAC RAS to fit mine, just took a rotary tool to the front clamp to make it match the profile underneath the front cap. You don't need to take a lot off, just need some patience.
I have two of these barrels and I’m trying to figure out my bolt carrier/buffer combo. I plan on running VLTOR A5 buffers, Sprinco green springs, and A5H2/A5H3 weights.
These rifles will be ran both suppressed and unsurpassed. I’ve read about all the LMT Enhanced carrier hype, but I tend to stick with either KAC sand cutters or the JP full mass carriers. Anyone running any other carriers aside from the LMT with similar setups? Thoughts?
At danger of angering the necropost spirit...
I’ve run this setup with a BCM phosphate carrier and a Sionics NP3 carrier. Functioned fine, though a little gassy in the face when suppressed. I think I was running an A5H3 buffer with green spring...
Because these barrels are gassed correctly, its no magic equation to make them run. A lot of different combos will work, hence the beauty of the Sionics RGP barrel.
PB