Magclip question

I was trying to install these on pmags to see how I liked them, and they seem to small to fit. No matter how hard I squeeze them together I can’t get them even close to be being able to start threading the screw. Am I missing something.

https://s26.postimg.cc/9jw8nd2op/728...DA7_A17_D2.jpg

From their website:

https://cryeprecision.com/ProductDet...gclip-set-of-3

"NOTE: CURRENT MAGCLIP™ IS NOT COMPATIBLE WITH MAGPUL® PMAG® GEN M3™ MAGS."

Just also noticed that it's a 300blk mag. I'm not sure about the external geometry, but I know the internal is different in those, so that may be part of the problem as well.

crye's site says NOT compatible with Gen 3 mags. The only 300 mags MagPul sell are Gen 3 to the best of my knowledge.

Quote:

---

Originally Posted by dreamcrusher8307

Just also noticed that it's a 300blk mag. I'm not sure about the external geometry, but I know the internal is different in those, so that may be part of the problem as well.

---

I tried it on 5.56 Gen3 pmag with the same result.

Quote:

---

Originally Posted by GH41

crye's site says NOT compatible with Gen 3 mags. The only 300 mags MagPul sell are Gen 3 to the best of my knowledge.

---

Ok thanks, I missed that.