PROBLEM FIXED! :D
Printable View
PROBLEM FIXED! :D
Who installed the gas block and FSB? Can't they make the repairs? Or you just do not want their booger hooks on it again, fearing they will make it worse?
I'd touch base with Robb Jensen at VA Arms and/or Grant Timberlake at G&R Tactical. Both of them have done awesome work for me.
Contact ADCO and see if they can help you get your canted FSB straightened out
If you are in Cal, you may need to have "an assault weapon certified" smith work on it. Evans gun works(?) in Anaheim can work on registered assault weapons. If it is an off list lower gun, I think anyone can work on it.
I know of two smiths in SoCal, if you need their names let me know.
I wouldn't take it to Joe Gunsmith down the street for such a job, either for installing the thing and especially not fixing it if it's screwed up. Too many bubbas with a drill press but no jig. If the FSB was installed off-vertical on the barrel...that's bad. Not sure how you'd fix that, but you should check with ADCO about your options. I've had ADCO install a few FSB's for me and they've done an excellent job. If I were you, I'd be pricing new barrels too.
.
Perhaps someone qualified can properly align it and pin it through the top side?
PM Iraqgunz.
Is it pinned or clamped on with screws? If I is clamped on just loosen the screws and turn it to line it up.
Its clamped on....can't you just loosen it and adjust.
Sent from my DROIDX using Tapatalk 2