Originally Posted by
Zane1844
Yeah I am going to use Brownells Aluma-Hyde II in Coyote.
And, the video link did not show up, if you left one.
Thanks for all your help, man!
Also, I am not too worried about it since the correct torque was most likely applied (about 20lbs) however: when installing the BCM Comp, I only had to move about 40 to 50 degrees max, past hand tight, to get it aligned properly, does the crush washer need to be crushed more than that? I read it can be crushed from 40-340 degrees so I think it is good, but just curious.