Did I make a bad call on my first build?
I am in the process of building my first AR and now that I have 95% of the parts I need, I am wondering if I should make it a piston rifle rather than a DI.
Now I’m not looking to open up the Piston vs. DI can of worms, but if I choose to go the piston route;
1. What parts that I already have am I going to need to replace/substitute (list below)?
2. What piston components are recommended?
Thanks Fellas!
Current parts:
• Vltor MUR Upper w/ Bolt Assist & Shell Deflector
• Spikes Tactical Stripped Lower Receiver
• BCM Bolt Carrier Group (MPI) – Auto
• BCM BFH 16" Mid Length Barrel, Stripped
• BCM Low Profile Gas Block (steel with set screws) 750
• Centurion Arms C4 Rail System - 12-inch Mid Length
• Griffin Armament M4SD-II Flash Comp
• Vltor A5 Buffer & Recoil System
• ERGO 2 Grip