Masking Tape just ate away KMR's Black finish?
I painted my AR today with Rustoleum, the results are alright, some oil on the lower kind of ruined it, but all in all its good.
I just took the tape off the front iron sight, I did not remove them when painting- I should have, but I usually keep them on since they do not come off, and noticed that the tape overlapped onto the rail. When I took it off the finish seemed all 'shriveled' up so I scratched it with my finger and it came right off and now it is white. The tape was on for around 8 hours, a couple of them were in the sun.
I will most likely spray it down real quick tomorrow, however, is the 'white' a finish as well?
This is no complaint about BCM, so I will not contact them, it is my fault. Also, as I understand the rail is still protected from corrosion by a clear finish, so I am not worried.