Gas Block Internal Diameter, How Big is Too Big?
I have two 10.5 inch Nitrided finish barrels and two Odin Works nitrided finish low profile gas blocks for a couple pistol builds. I slid both gas blocks on the barrels and both slid on and rotate freely on the barrels. My previous builds have used WOA stainless barrels and Troy or MI low profile gas blocks. Those were all snug fits and required a hardwood block and small hammer to fit. Both 10.5 inch barrels measure .750 exactly at the gas port. The internal diameter of the Odin Works gas blocks measured .752 and .7535. Odin Works states the internal diameter between .7505-0.751. Is this going to be a potential problem or is this within an acceptable range?
https://www.odinworks.com/Low_Profil...ck_p/gb-75.htm