A simple calculation to help find the best buffer/spring combo
For my first build I went to great lengths to find an ideal buffer and spring configuration for my gun. I wanted my build to be a sweet shooter, so I started out with a 14.5" middy for its purported benefits over a carbine length gas system in combination with an M16 BCG. To tune the buffer and spring to the rest of the gun I turned to the forums but I was discouraged by the trial-and-error approach that is commonly advised. I didn't want to buy a bunch of extra parts and I wanted an answer that would satisfy my perfectionist side.
Due to the lack of hard numbers out there I had to find a way to mathematically represent different combinations of buffer weight and spring tension in order to find an optimal compromise between reliability and reduced recoil. Now, I am by no means an engineer or an expert so take all this with a grain of salt.
To start with, I dug up a chart of technical info on the forums that states that a Colt GI carbine spring imparts 6.040 lbs of force when compressed to 6.902". A standard H buffer weighs 3.8 oz. Since both of these components work in combination with each other I decided to use the product of the measurements as a unit of comparison. In order to do so I multiplied the spring weight by 16 so that the measurement would be in oz. So 6.040 x 16 = 96.64 and when multiplied by the buffer weight of 3.8 oz, we get a product of 367 units. Units of what you ask? **** if I know; like I said, I'm not an engineer. Think of this number as a unit of comparison.
So now that we have a number for the intended setup for a 14.5 middy we need to find a number for the point at which a setup will induce short cycling with the weakest ammo that you intend to use. According to various anecdotal reports, a Sprinco blue spring with an H2 buffer is where we will commonly start to see short stroking.
To get the info needed for this, I emailed Sprinco to find out how much heavier their blue spring is than stock. I got a prompt response of 17% (thanks Alan). This info coincided with the numbers on the chart that I dug up earlier so at this point I was starting to feel pretty good. So using our previous formula, a Sprinco blue with H2 buffer gets us 548 units.
By now, I assume that we are both on the same page, so in the interest of brevity I am going to present to you the information just as it appears on my notepad.
GI spring H buffer 367* intended weight
Sprinco blue H2 short cycles wolf 548
GI spring H2 does not 444
Failure point is somewhere in the middle at 496 (presumed)
15% below failure rate is ideal
(421)
367* 26% below failure rate of 496
405 18% below failure rate
429 14% below failure rate
452 9% below failure rate
GI spring H 367* intended weight
GI spring ST-T2 406
GI spring H2 444
Blue spring C 357
Blue spring H 452
Blue spring ST-T2 500
JP spring H 393
JP spring ST-T2 434
The setup I arrived at is the JP tuned and polished extra power buffer spring (7% stronger than USGI) and the Spikes ST-T2 buffer. This setup is a comfortable margin below the failure rate while still being 15% heavier than the stock setup. As a basis for comparison, M193 ammo is very roughly 10% "hotter" than bottom of the barrel (think wolf) .223 ammo. As an added benefit, both of these components offer a reduction in cycling noise, and the ST-T2 does not rattle when shaken like a standard buffer would. I should also mention that my rifle functions perfectly with whatever I feed it.
So there you have it. I realize the unscientificness of this study, so feel free to pick it apart.
A simple calculation to help find the best buffer/spring combo
Holy overthinking Batman!
A brief search here would've lead you to using a standard H buffer (I prefer an H2 in my 14.5" w/ my ammo choice) or an A5H3. The trial & error has already been done and all that info is here at your fingertips. It's still dependent on an individual's ammo selection so there's varying setups.
I'm afraid your "calculations" may have lead you to the worst option based on the opinions of many here. There's only a very small following for the Spikes set up. The majority of experts here steer away from it.
But hey, if it works for you, roll with it.