Yea I'd say no go at that price. But that's my opinion.
Printable View
I think you can look at this in two ways. One is to get an in spec lower that you love the rollmark on. As stated before you will have this lower forever. One of my SBRs is an Umbrella lower. I got it just because I like the roll mark and its a good in spec lower. It has a colt lpk in it, I measured to make sure its in spec and I know its a good lower. At the end of the day, what you want a solid foundation.
The second way to look at it is to buy an off the shelf prebuilt lower like BCM, Daniel Defence, or LMT. The rollmark may not be as nice as Umbrella or Noveske but they will be an outstanding foundation for your SBR.
Well...i appreciate all of the feedback and I was browsing a bit and settled on a wilson combat, forged with integral Trigger guard.
I looked at wilson a day or two ago and the had no stock. Tonight they did so I went with it.
Not a shabby price. I kinda dig their gray combos. Hmm
Agreed and no doubts at all in my mind about the quality!
Nice!
May I butt-in with a noob question?
My SBR stamp came in last month, and I'm SBR'ing a Noveske Gen 2 lower. My next step is the engraver. BUT... I went the "Individual' route and ATF made me put my full name as the manufacturer .. so that's a frickin 22 character top line and Saint Louis, MO as my 2nd line! Where the hell would you all recommend the engraving at? I'm thinking I'm screwed and have to go on the trigger pin area, but someone said earlier in this thread 'inside the magwell'. Can someone clue me in please? Thank you!
Attachment 31866
Not sure of everyone's opinions on legality, but that's probably what was meant.
BCM Lower from G&R Tactical + 11.5" w/ KMR BCM upper = DONE.