Yes.
C4
Printable View
ANy idea of the timeline for getting the B&T suppressor that mounts like a Gemtech Halo. Need one for a sig 551.
When are we gonna start seeing the APC300? Any idea what barrel length those will have?
Is there a set of flip-up BUIS that will co-witness with a T1 in a B&T throw lever mount (low)?
The Troy Low Profile Micro Sights are about the only ones I have found.
ETA: The Troy Low Profile Micro Sights are not low enough.
I've been looking at the same issue for my APC223. The B&T buis are standard AR height at 36mm and are too high to cowitness with the T1 in the B&T mount where the center height is around 19mm. I think B&T should have used lower buis though, perhaps similar to the Troy micros.
I can't speak with direct personal experience, but I believe the Troy micros are 29mm high and the T1 in an ADM CASV mount has a centerline height of 29mm so they should cowitness. Again, I have not tried this personally to confirm.
Try the Troy micros with the American Defense T1 CASV mount, it should line up, at least according to the listed measurements.
https://www.americandefensemanufactu...ew/product/46/
I don't know of any buis low enough to be seen through the T1 on the B&T mount, but if you find any, let me know.
Best