Might try reaching out to BigWaylon. He posted some a while back that he made.
https://www.m4carbine.net/showthread...99#post2115299
Printable View
Might try reaching out to BigWaylon. He posted some a while back that he made.
https://www.m4carbine.net/showthread...99#post2115299
I can’t vouch for the info on the site but there is a dedicated form 1 board.
https://form1suppressor.boards.net/b...cussion?page=2
Sounds like Pappabear will have more man hours in getting the F1 e-submitted than I will building the can....
Following this as I'm planning on doing the same.
If any of you guys are on bookface there are a couple good groups to follow. Lots of info out there.
Also The form1 suppressor boards linked early is legit.
Sent from my iPhone using Tapatalk
Got the eforms submitted today. Sending in prints tomorrow. Process in full motion. Shout out to Big D for the help.
I’ll keep everyone up to date.
PB
Intrigued to see how this works out. I know that the cost will be comparable to a purchased can, but the allure of the "do it yourself" work is quite neat. Also, the fact that you're the manufacturer should make repair significantly easier should you need to change anything.
That's the thing. We got one extra end cap that could be drilled out if we got a cap strike. There was another dealer that had similar kits her in AZ, but they quit selling the parts supposedly due to the ATF. So having repair parts isn't a bad idea with the way ATF just makes shit up as they go.