Thin-wall EMT conduit; get two sections, bend a 90* on one end of each to form an inverted "L", use conduit hangers to attach to back of workbench with the short lengths positioned over the bench, hang light... ;)
Printable View
My next question is:
Where do you guys have your vice positioned...?
Probably the position I'll end up going with. The left side is most likely going to be up against my locker. I installed 6 of the modular panels of pegboard yesterday, so the project is moving ahead.
What sorta vice you got, Rob?
Same here. I have a Wilton multi vise on the right side. That's how we are set up in my shop and at the schoolhouse.
Pics, or none of this happened. ;)
No shame there, dude. My policy on HF's goodies is that if it doesn't involve electricity, it's good enough for my amateur endeavors.
Unless I decide to start torquing barrels, something cheap that works should fit the bill.
What sort of vice blocks are you rocking?
Just an idea for table top, gun protection. Roll-on or brush-on bed liner material ,A lot of colors ,tough as nails ,etc.