Ahhh...you are correct. I should have read more carefully.
Printable View
i want to do this to the M&P on the side of my lower pretty bad. Tried sharpie already but it doesnt last.
These were done using BC Alumablack.
H1 Aimpoint logo did good.
http://lh3.ggpht.com/_5kA3JwNkBxc/TI..._picture-1.jpg
BCM logo on upper only darkened enough to subdue it a bit. The flash makes it appear lighter than it is.
http://lh5.ggpht.com/_5kA3JwNkBxc/TI...ms_picture.jpg
this is interesting...
http://www.thehighroad.org/showthread.php?t=466996
Tag for a good thread,
So far I've degreased and tried a black sharpie, which works pretty good but isn't durable. After playing around with it, I used some solvent and removed all the sharpie and then tried a Birchwood Casey paint pen I had. It didn't work as well as the sharpie.
I don't have a lacquer stick, but I think those work better for engraving that has depth. Since there's nothing to fill in here, I don't know if a lacquer stick would work so well.
If it's engraved or etched it has a little depth--lacquer stick should do you fine.