Randall
any idea for Roll Pin Punch sizes and holders?
Thanks
Printable View
Randall
any idea for Roll Pin Punch sizes and holders?
Thanks
The only roll pin holder that's been necessary enough for me to make is the 5/64" for gas tube pins and the 1/16" for charging handles.
Everything else is long enough that you can start them by holding them.
If you really like holders, just get 1/16, 5/64, 3/32, 1/8 & 5/32 and you will be better prepared than me.
I use needle-nose vice-grips to compress the roll pins a bit for starting them.