Installed a SDC what did I do ....
So I installed a Geissele SD-C and went to the range to test fire the trigger. When I changed the safety to fire the trigger released with no problem, but I noticed that there was no reset to re-engage (with another round), the trigger would not release while in the fire mode. To re-engage, I had to move the selector back to safe then fire to re-engage.
I thought that maybe it was due to the safety selector was affecting this operation. When I switched (I am left handed and so it was on the right side of the reciever) to the left and then performed another function check same problem.
Any thoughts on what I did wrong?:confused