It HAS TO say LWRC on the side!! :haha:
Just kidding! :no:
Printable View
It HAS TO say LWRC on the side!! :haha:
Just kidding! :no:
A bag of snickers.
for me its.. just about any lower.. and then uppers in..
BCM $
PSA $
DD $$
Colt $$$
Mil-Spec BCG, and 1/7 twist or 1/8 twist.. no 1/9 for me..
I like the BCM but I wanted an option to put a FF tube on later.. and I wanted them to sub the std F marked FSB for a low-pro.. but they would not..
PSA did it and for no charge.. they also left the A2 flash-hider loose so I could more easily install my Brake (for pinning for NJ compliance)
I run a DPMS lower from my 1st AR15 size, and sold that DPMS upper (for $365) and bought the PSA upper (for $499) with Premium BCG..
http://executiveprotectionservice.us/forums/556/PSA.jpg
That being said.. if I ever get another it will be a 16" BCM in a Midlength and I'll just leave it be..
I wonder where this thread is headed? In any case I usually do not buy complete AR's. I prefer to assemble them myself or a least a large part of the work.
I want adherence to the TDP and or proven quality parts.
1. HP/MPI testing.
2. 1/7 twist barrels.
3. Milspec BCG.
4. Milspec .155 lower pins.
5. Milspec lower receiver extension.
6. Gas ports that aren't huge like Jenna Jamesons hole.
+ 1,000,000 on this, I feel like your in my head:happy:
The only thing I would add for me is a CHF barrel for prolonged barrel life and a 1/7 twist rate for shooting heavier grain bullets than 55grn (I prefer 62grn).
Also, it was stated above customer service is a huge factor for me. I have delt with other "lesser quality" companies in the past (I dont want to mention names) and what put them even further down on the list was absolute horrible customer service.
I am a huge supporter/user of Daniel Defense, never mind the fact that they make an absolutely un paralleled product/rifle thier customer service is the best I have ever seen in ANY company period, firearm and non firearm alike.
Another thing I like to see is companies that make their own stuff in house, i.e. they do not outsource their products to other shops to be built. That way their QC is top notch and the end user is less likely to have a bad product and if so, the company is able to take care of it in house.
Other than that, F2S has it right on the money
Just my opinion though