Trigger pull "feel" does not equal quality. So you cannot use that as a tool to judge if something is quality or not (when looking at USGI FCG).
C4
Printable View
What size is the standed pin size like DD,LMT DPMS,CMT,STAG,Bushmaster and so on?
thanks Grant.
I really like Daniel Defense lpk's. The trigger and selector both operate crisply. DD also makes everything but the springs in-house.
One thing I've noticed about lesser quality lpk's is the hardness of the parts. After about 200 rounds on a bushmaster lpk i had, I noticed a small divot forming in the bolt catch where the bolt lugs run across it. The DD lpk I am currently using does not exhibit this divot after nearly 800 rounds.
If you want the best, go with Colt. I've been ordering from Specialized Armament and getting just the parts I need since I always replace the mag catch, selector, and trigger anyway. Only downside with SA is the cost of shipping. It will cost you a little more but you could always go this route and then pick up one of the new ALG Defense triggers.
Got mine one from Grant and one from PSA. Can't really tell the difference other than the PSA one came with a weird looking safety selector and was cheaper. But I am a total noob.
Can't say anything negative about either to be honest.
I'm not sure, but I heard Noveske uses Stag. I have a factory built Noveske w/Geissele SSA trigger. Good setup, or should I do something about it?