Page 5 of 5 FirstFirst ... 345
Results 41 to 42 of 42

Thread: Buffer Retaining Pin....Is this ok??

  1. #41
    Join Date
    Nov 2011
    Posts
    440
    Feedback Score
    17 (100%)
    I couldn't imagine why, the end result is the same either way. I am not sure I would be so quick to call any lower or RE defective if this problem were to present itself. I would attribute it to tolerance stacking.

    I can't imagine that the thread roller or tap is engaging every RE and every lower at the same place every time on every piece at every manufacturer. So there are going to be some differences in where the threads start which will result in slight differences and once in a blue moon, a problem like this.

    If this level of quality control like this existed in firearms, screws would be tightened by the number of turns and not torque.
    Last edited by tonyxcom; 04-30-12 at 17:21.

  2. #42
    Join Date
    Apr 2012
    Location
    New Jersey
    Posts
    1
    Feedback Score
    0

    Unhappy

    I think you'll be okay with it. Just check it out frequently after you fire.

Page 5 of 5 FirstFirst ... 345

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •