Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: Trigger wont reset!

  1. #21
    Join Date
    Mar 2009
    Posts
    4
    Feedback Score
    0
    Yep boomer 10 it was ment for you .sorry I missread Cal.Of your upper not used to seeing the 5.7 around .
    HERE is A test for your disconector to finally eliminate it as the problem.
    with upper off the rifle Hammer forward...pull trigger,While continuing to hold trigger to the rear use offhand thumb to cock hammer all the way back,it SHOULD be retained by the disconector and that hook on the underside of the hammer.
    Next, very very slowly take your finger off the trigger.
    The hammer should attempt to go foreward but only jump a small amount and be stopped by the primary sear notch, continuing to release untill finger pressure is off should leave it in the ready to fire position if you pull back on trigger it will fall all the way foreward .
    If you are doing a very very slow trigger release and the hammer flys foreward without stoping then it is not the upper .
    I'll shutup now and go back to lurking.
    Good luck.

  2. #22
    Join Date
    Jun 2006
    Location
    Langhorne, PA
    Posts
    253
    Feedback Score
    3 (100%)
    Quote Originally Posted by dragonguard View Post
    Yep boomer 10 it was ment for you .sorry I missread Cal.Of your upper not used to seeing the 5.7 around .
    HERE is A test for your disconector to finally eliminate it as the problem.
    with upper off the rifle Hammer forward...pull trigger,While continuing to hold trigger to the rear use offhand thumb to cock hammer all the way back,it SHOULD be retained by the disconector and that hook on the underside of the hammer.
    Next, very very slowly take your finger off the trigger.
    The hammer should attempt to go foreward but only jump a small amount and be stopped by the primary sear notch, continuing to release untill finger pressure is off should leave it in the ready to fire position if you pull back on trigger it will fall all the way foreward .
    If you are doing a very very slow trigger release and the hammer flys foreward without stoping then it is not the upper .
    I'll shutup now and go back to lurking.
    Good luck.
    After reading your post last night I again went and grabbed the lower and already did those basic tests just to confirm it to myself AGAIN (I can't tell you how many times I've done that since I started having issues with this upper).

    I do appreciate the help though.

Page 3 of 3 FirstFirst 123

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •