When I put my Aimpoint in the mount it was as tight as it would go, but the mount did not clamp completely on the top, there was still a small gap. Now I just checked it after shooting a few hundred rounds over the past couple weeks of having it, and its moving very very slightly, I cannot even see the optic move, just feel it.
When I shot it last weekend, I was not going for accuracy at all, but was able to hit what I aimed at, at variable distances. But I want it clamped tight.
Why wont the screws go any farther to tighten down harder? On side the screw, though difficult because of Loctite and the fact it would go no further before, would tighten slightly. The other will not budge.
Should I remove it? Because I will want to take it to the 100 yard range again and check its zero. I am really strict on making sure my optic or iron sights are zeroed to what I consider acceptable.
Reply With Quote
Originally Posted by Kenneth
Bookmarks