Different colors should be "flashed", or semi cured for 15 minutes @ 150 degrees before adding another color.
|
||||||||||||||||||||||||||||||||||||||
Different colors should be "flashed", or semi cured for 15 minutes @ 150 degrees before adding another color.
gator is correct, or you can also do a "wet on wet" application of all colors at once if you pattern is to be free-handed...good luck.
"I would rather be the hammer than the anvil."- Rommel
Owner: Hangar 18 Custom Coatings
I got an email back from Cerakote....here's their advice:
Flash cure for 15 minutes at 225 degrees. At this point you can tape and stencil for your camo pattern. Flash cure each additional layer you spray on. Spray lightly so you don't make "hard lines" that look like stickers. Then final cure the whole thing when you're done with your camo pattern.
Bookmarks