|
||||||||||||||||||||||||||||||||||||||
Last edited by sinlessorrow; 05-16-13 at 23:25.
Not an X300U, however I have 3 X300 lights that will only go on my rails with a mallet. 3 different URXIII rails, DD MK18 rail, DD RIS II and RIS II FSP rails and a a KAC RAS.
I've done everything I could in regards to tightening them down on the rails. I went so far as to have the screws in just enough to secure the mount to the light and then monkeyed with the final assembly on the rails. It's a no to all around.
I was thinking about sanding the mount down as another poster mentioned but I didn't want to lose the ability to securely mount them to my Glocks if I have to switch over.
Bookmarks