Magpul Mossberg stock/forend release date

[tommyrott]

any chance for a butt stock for the 930?

[masakari]

What exactly did you have to modify to fit and allow trigger removal? Did you install the rear RSA sling attachment???

no I dont have the rear sling mount, as I only use QD swivels.
but it was simple, only the semi-circulat cutout potrion that contacts the trigger housing needs to be sanded to fit. you will need a small drum dremel bit, and thats it. Took 20 minutes with child interruptions haha.

[mini14gb]

no I dont have the rear sling mount, as I only use QD swivels.
but it was simple, only the semi-circulat cutout potrion that contacts the trigger housing needs to be sanded to fit. you will need a small drum dremel bit, and thats it. Took 20 minutes with child interruptions haha.

Masakari,
Any chance we could get you to post a picture of your modified Magpul stock so I can gauge how much material to remove?

[jerhelo]

Pictures kind of suck, phone pics, will put some better pics up soon.

Mossberg 590a1 with flat black cerakoted barrel, Magpul SGA and Forend, rear sling attachment and forward sling attachment, mesa tactical sidesaddle.

Attachment 22314Attachment 22313

[mini14gb]

I was actually wanting the specific picture of where he modified the stock so the trigger assembly can be removed.

Pictures kind of suck, phone pics, will put some better pics up soon.

Mossberg 590a1 with flat black cerakoted barrel, Magpul SGA and Forend, rear sling attachment and forward sling attachment, mesa tactical sidesaddle.

Attachment 22314Attachment 22313

[Achilles11B]

If only I could get one for my 930.

[jerhelo]

I wasn't posting to you mini14gb, just generally posting...

I did modify mine to allow the trigger to be removed with the stock installed though and it was fairly easy. I removed the factory stock and trigger pin and placed the stock in place by hand to see where it hits. I pulled the trigger out and began removing material with a dremmel. It is almost impossible to show you because it is a small amount of material in the round part where the trigger slips into. Make sure you you angle the dremmel in a 90 degree motion as the trigger rotates out it hits.

Took about 8 minutes and you have to remove about 1/8" to 3/16" of material with a drum sander bit.