I recently purchased a UBR stock and am trying to switch the rear QD mount to the right side of the stock. Instructions say to install a QD swivel and pull the mount out but I'm not having any luck. Any suggestions?
|
||||||||||||||||||||||||||||||||||||||
I recently purchased a UBR stock and am trying to switch the rear QD mount to the right side of the stock. Instructions say to install a QD swivel and pull the mount out but I'm not having any luck. Any suggestions?
Down in the bottom of the cup is a screw. It has to be removed before the cup can come out. There may be a nut holding the screw on the opposite side
INSIDE PLAN OF BOX
- ROAD-RUNNER LIFTS GLASS OF WATER- PULLING UP MATCH
- MATCH SCRATCHES ON MATCH-BOX
- MATCH LIGHTS FUSE TO TNT
- BOOM!
- HA-HA!!
-WILE E. COYOTE, AUTHOR OF "EVERYTHING I NEEDED TO KNOW IN LIFE, I LEARNED FROM GOLDBERG & MURPHY"
I am American
You did remove the screw, right? They are in there tight, but they usually pull free with the QD.
Duane Liptak, Jr.
Executive Vice President
Magpul Industries
info@magpulcore.com
This is a personal account linked to a personal e-mail. Company affiliation and titles are provided purely for transparency requirements of the host site. Although factual company information may be shared through this account, any opinions expressed are solely those of the account holder, and not necessarily those of Magpul Industries or subsidiaries.
put a sling with a QD on it in the socket, kneel on the stock, and pull up on the sling. I've never seen one that wouldn't come free from that. You must have won the "min diameter hole, max diameter QD cup" lottery.
Duane Liptak, Jr.
Executive Vice President
Magpul Industries
info@magpulcore.com
This is a personal account linked to a personal e-mail. Company affiliation and titles are provided purely for transparency requirements of the host site. Although factual company information may be shared through this account, any opinions expressed are solely those of the account holder, and not necessarily those of Magpul Industries or subsidiaries.
Duane Liptak, Jr.
Executive Vice President
Magpul Industries
info@magpulcore.com
This is a personal account linked to a personal e-mail. Company affiliation and titles are provided purely for transparency requirements of the host site. Although factual company information may be shared through this account, any opinions expressed are solely those of the account holder, and not necessarily those of Magpul Industries or subsidiaries.
Duane Liptak, Jr.
Executive Vice President
Magpul Industries
info@magpulcore.com
This is a personal account linked to a personal e-mail. Company affiliation and titles are provided purely for transparency requirements of the host site. Although factual company information may be shared through this account, any opinions expressed are solely those of the account holder, and not necessarily those of Magpul Industries or subsidiaries.
Glad to see I am not the only one... LOL. I was trying to get mine out the other day and gave up. You're story gave me hope and I think I'll try again tonight.
The previous owner did pain the stock and that may contribute to stubbornness of mine... though I did strip the paint.
Last edited by pyzik; 07-22-13 at 16:28.
Bookmarks