Page 3 of 3 FirstFirst 123
Results 21 to 21 of 21

Thread: Carrier Key Staking Tool?

  1. #21
    Join Date
    Feb 2008
    Location
    Washington
    Posts
    772
    Feedback Score
    0
    Quote Originally Posted by ABNAK View Post
    I have the original MOACKS; has a firing pin scraper, bolt tail scraper, and detachable carrier scraper. It has four screws (two on each side) and a groove where you can actually see the staking take place.

    As far as the Enhanced BCG, I got it from Rainier and they said it was the latest iteration (as of a month or so ago).
    Does the carrier have the full length guide rails or the short Enhanced guide rails?

    Did the carrier wobble or fit loosely in the tool at all?

    Is it possible for you to post a picture of the staking? If the carrier has the short Enhanced guide rails I imagine that the staking on the screw closest to the bolt would be shallower (higher on the staking rail) or deeper (lower on the staking rail) than the staking on the rear screw.
    Last edited by 556Cliff; 10-04-13 at 11:42.

Page 3 of 3 FirstFirst 123

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •