is all glock 3.5 disconnect created equal

[skt4271]

Thinking of getting, but are they essentially all the same?

[okie john]

Thinking of getting, but are they essentially all the same?

Some of the aftermarket ones are known to break. Stick to OEM for best results.


Okie John

[sammage]

OEM is consistent. Scherer have been known to have issues.

[skt4271]

Thanks, the OEM is cheaper anyway.

[tonyxcom]

I have 2 Ghost 3.5lb disconnectors, one of them with the tab you file down to limit overtravel and a standard one.

I hate them.

They are mushy with inconsistent breaks.

I much prefer the Glock - and "dot" connectors with the Wolf competition trigger spring.

[iLift45s]

Vanekcustom.com

Charlie makes the best trigger kits and parts out there. I love them in my Glocks!

[T2C]

OEM is consistent. Scherer have been known to have issues.

What kind of issues? I have a Scherer disconnector in a Glock 22 and have not run into any problems yet.

[jcshelto]

In my experience, no, the different connectors are vastly different, mostly in feel and trigger pull nuance.

I have also experienced that there is great variation between even OEM 3.5 (4.5) connectors. I got a Glock 34Gen4 with an OEM - connector that was garbage. Even an OEM dot connector was an improvement. I ended up trashing it and replacing it with a Lone Wolf. I also bought a used Glock 24 that came with a Ghost connector, and I was very unhappy with the trigger pull. Replaced it with a Zev, and am much happier.

The most consistent connector I have found thus far is the Lone Wolf. I really like it. I am not sure I would pay the money for the OEM.

They are relatively cheap--I would try a few. If I were in your boat, I would pick up the Charlie Vanek custom connector. I have never heard a bad thing about it. I avoid Ghost, after some bad experiences.

[skt4271]

I looked on lone wolf, they don't offer a OEM 3.5 by glock? I may try theirs LW.

[sammage]

What kind of issues? I have a Scherer disconnector in a Glock 22 and have not run into any problems yet.

Have heard a few reports of them bending. A friend had one for a while, and reset was spongy compared to the OEM.

After trying the 3.5, I have moved onto the dot connector.