Scalarworks Micro mount.

[montrala]

I know some people, who for this distortion reasons prefer to put their rear sight in front of optical sight (Eotech in their case). This is also a reason why our military is requesting to put iron sights under optic (hollow channel in rail in wz.96/06 Beryl or high rail with see trough base in UKM-2000). They just do not believe in co-witness trough optic.

BTW I wonder if HK 28.5mm sights from HK416 would look under Micro using this Scalarworks mount.

[Scalarworks]

The mount is really nice and the clicks of the knob were much firmer than I was expecting. I bet that low drag knob would work great to make screws on keymod accessories more QDish! You heard it here first!

Thanks for sharing your initial impressions, Tony. Glad you like it so far.

BTW I wonder if HK 28.5mm sights from HK416 would look under Micro using this Scalarworks mount.

The max height above rail of the pocket on the Scalarworks LDM110 (taller lower-third mount) is 21.46mm.

The problem with the over/under configuration is that either the irons, the optics, or both will have a compromised height to accommodate the other.

[montrala]

The problem with the over/under configuration is that either the irons, the optics, or both will have a compromised height to accommodate the other.

I know. But seems like on this side of the pond (at least in my neighborhood), we are not so focused on getting tight cheekweld on assault rifle with red dot sight. Actually some people say it is better not to have any cheekweld, when using gas mask.

Anyway, very nice mount

[Scalarworks]

Anyway, very nice mount

Dziękuję

[Hochsitz]

Have any of you guys had a chance to shoot irons with and without the T1 between them to confirm the point of aim change? From the picture I posted and comments from others it seems clear the effect is real. But how much is it exactly?

[jerrysimons]

Have any of you guys had a chance to shoot irons with and without the T1 between them to confirm the point of aim change? From the picture I posted and comments from others it seems clear the effect is real. But how much is it exactly?

Anyway for the purposes of this thread it is remarkable that ScalarWorks has made such a lightweight QD T1 mount where QD is an important feature that has been lacking from other lightweight mounts. I think we should make a new thread about the issue of iron sight zero subject to parallax viewed through the rds optic, it would probably get more hits and it wouldn't be off topic in its own thread.

[Hochsitz]

Good idea. Ideally we would get as many brands as possible involved and see if some are better than others.

[broberts001]

Any more feedback on this mount ?

-Bryan

[jerrysimons]

How can we get a replacement detent wheel with the torx center that LAV has posted? Thanks.

[Scalarworks]

How can we get a replacement detent wheel with the torx center that LAV has posted? Thanks.

Shoot us an email with a copy of your invoice and shipping address and we'll send you one free of charge.

Alternatively post up a pic of a rifle with your LDM on it to @scalarworks (instagram or twitter) and DM or email us your shipping address.