Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: SBR Lower Caliber Marking Question

  1. #11
    Join Date
    Dec 2013
    Location
    Charlotte, NC
    Posts
    1,591
    Feedback Score
    0
    Important to note about the above reply...the quoted section near the bottom is for serial number only. There is no minimum size requirement for any of the other required markings, only the .003" minimum depth. The SN has the additional 1/16" minimum size requirement.

  2. #12
    Join Date
    Apr 2012
    Location
    South Louisiana
    Posts
    62
    Feedback Score
    7 (100%)
    Quote Originally Posted by BigWaylon View Post
    Important to note about the above reply...the quoted section near the bottom is for serial number only. There is no minimum size requirement for any of the other required markings, only the .003" minimum depth. The SN has the additional 1/16" minimum size requirement.
    Thanks I didn't realize that, but should have. That's why I went with THSF because their specialty is engraving that tiny print in the trigger area without stripping the lower. Thanks to whoever recommended them in a thread here somewhere.

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •