I wanted to clarify, I did ask one of the Moderators for permission. I want to thank everyone for the interest in the tags.
|
||||||||||||||||||||||||||||||||||||||
I wanted to clarify, I did ask one of the Moderators for permission. I want to thank everyone for the interest in the tags.
Owner of Carolina Laser Works
https://carolinalaserworks.ecwid.com
No, but i can actually use the laser to cut a standard tag down to the mk25 size. I need to find my specs on the mk25 tags. If you have the exact dimensions available it would make it easier. The (consumer) mk25 tags from Sig are a polymer. These would be the metal tags which are rated at 20 years (average use from the manufacturer).
Owner of Carolina Laser Works
https://carolinalaserworks.ecwid.com
Last edited by Dionysusigma; 04-07-17 at 21:48.
I will get the Mk25 tag specs and try to upload it to my website tomorrow. Thanks again
Owner of Carolina Laser Works
https://carolinalaserworks.ecwid.com
Thanks just ordered three on your website....nice site and very easy process!
Thank you, it is a simple site, but sometimes simple is easier. I am tracking the new blanks and will engrave and ship them ASAP. I think you guys will like them.
Last edited by CharlieDeltaJuliet; 04-07-17 at 22:59.
Owner of Carolina Laser Works
https://carolinalaserworks.ecwid.com
Absolutely. I get permission from the University, (usually with a phone call and them emailing me a waiver) most will give it openly for small items not mass produced like a coaster. I have only seen one that will not give permission for a full emblem and that was Ohio State.
Owner of Carolina Laser Works
https://carolinalaserworks.ecwid.com
Bookmarks