
Originally Posted by
Doc Safari
This UTG Pro handguard I just installed required NO hand-fitting or modification. I didn't even have to "flex" it to get it in place. It has a couple of set screws that butt up against the teeth of the barrel nut/delta ring area to keep it in place. It assembles with two screws on each side to hold the rails together, and the front of the handguards actually fit tightly OVER the front handguard cap. All in all it feels pretty rigid. Not sure how it will be after 1,000 rounds. I'm hoping the moniker "UTG Pro" somehow indicates the company is manufacturing these to a higher standard to capture some of the serious user market. We'll see. Maybe the Midwest Industries equivalent is better? It's a little more expensive. As long as material and manufacturing specs are comparable, I don't see a dime's worth of difference.
Can you send me a link so I can see how it interfaces with the handguard cap?
RLTW
“Your posts will be more accurate and received much better if you form your opinions with less emotion and more objectivity and then express them as if you’re in a discussion with friends, rather than an injured and cornered animal fighting for its life.” -Revolution 9 on the hide
Bookmarks