Originally Posted by
Bryson
I have an SLR GB-7 low-pro gas block and a Daniel Defense barrel that DD no longer sells (16" mid-length S2W). The gas block comes with a roll pin, but I'd like to use a taper pin instead. Is there a go-to gunsmith that the M4C hive mind recommends? Need the barrel drilled for both the set screw and the pin, and the gas block has a starter hole where the roll pin goes but needs to be drilled as well (which is why I'm assuming I can convert this to a taper pin).
Thanks.
(Also, if I'm wrong about preferring a taper pin please educate me.)
My correspondence with Criterion Barrels Tech Support told me that they do not recommend using taper or roll pins, just set screws, and the taper pins displace barrel material and both can affect harmonics. Here is a quote from them...
"From: CBI Customer Service
Sent: Monday, May 14, 2018 1:10 PM
To: 'John'
Subject: RE: Enquiry John
John,
I think that you would be very well pleased with one of our chrome lined barrels. In my opinion they are the finest chrome lined barrels available anywhere and our record speaks for itself. We hold numerous National Match titles and world records that were shot with our chrome lined barrels. Head-spacing is essential to obtain optimal timing, function, and performance. An improperly head-spaced barrel/bolt combination results in inconsistent chamber pressures which leads to premature wear on internal components like the extractor and the chamber walls. Inconsistent chamber pressures result in accuracy issues. Head-spacing directly relates to consistent seating depths which aids in accuracy and consistency. Lastly, I do not recommend pinning of the gas block, ever... When you drill a hole through the barrel and the gas block and then drive a taper pin through it, material is displaced. This frequently causes crimping of the bore, harmonics issues, etc. Although this practice has been used by the military for decades, it is something that they are moving away from in order to improve upon their 4 MOA accuracy requirements. As an example here is a recent article about a contract put out by the Marine Corps. Take note of the fourth bullet point under "Required Characteristics", it specifically stated that gas blocks are not to be pinned.
http://www.thefirearmblog.com/blog/2...kly+Newsletter
Working with a number of firearms manufacturers, I have seen issues occur time and time again as a result of this process. I recommend installing your low profile gas blocks with a small amount of thread locker in conjunction with our set screw dimple. If you snug the screws down (being careful not to over torque) to the barrel your gas block will not move until you want to remove it. I have tested this method under sustained full auto fire and have never had a gas block walk off on me... the only thing separating a hobbyist and a professional is knowledge, skill, and experience (something I work on obtaining every day). Let me know if you have any other questions.
Sincerely,
Michael Ross
CBI Technical Support
W172 N13050 Division Rd.
Germantown, WI 53022
Phone: (262) 628-8749
Office Fax: (262) 677-2554"
"A free people ought not only to be armed and disciplined, but they should have sufficient arms and ammunition to maintain a status of independence from any who might attempt to abuse them, which would include their own government."
- George Washington
"Some of you would bitch if a hot blonde served you a perfect steak and beer of choice while naked and performed acts not described." Mark5pt56
Bookmarks