G&R Tactical
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Idea for reloading bench

  1. #11
    Join Date
    Aug 2018
    Posts
    3
    Feedback Score
    0
    Andy ;i bought new full extention slides from lowes, but you need to cut the drawer width Not that hard with a table saw.i also converted the left two drawers into one deep drawer by removing the bottom of the top drawer and joining them with rafter plates
    Last edited by junkmansj; 09-09-18 at 19:02.

  2. #12
    Join Date
    Aug 2018
    Posts
    3
    Feedback Score
    0
    Factory door fully open.jpgNew Slides Fully open.jpgCUT DETAIL 2.jpg
    Quote Originally Posted by junkmansj View Post
    Andy ;i bought new full extention slides from lowes, but you need to cut the drawer width by about 5/8". Not that hard with a table saw.i also converted the left two drawers into one deep drawer by removing the bottom of the top drawer and joining them with rafter plates
    I need to correct my self, Its not 5/8" Cannot get other photos loaded. If you like I can send them by email. Center photo is with new full extension slides, other is factory slides fully open
    far right is the change you need to make for new slides
    Last edited by junkmansj; 09-09-18 at 19:02.

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •