Glock 19, gen 5 chamber diamentions

[jpgm]

Has anyone with a stock, gen 5 model 19, noticed the chamber is possibly too tight? Just a little background, I have been using the same Redding 9mm dies for a long time (around 8,000 rds at least). My gen 2 G19, VP9, and CZ P10C has shot the reloads with great success. On my family members gen5 G19, the brass is extremely difficult to remove from the chamber and causes stoppages. A brand new S T action pro dummy round had the same result today. I'm just wondering if anyone else is having the same issue.

jpgm

[boombotz401]

Gen 5 does have a shorter chamber but I haven’t had any stuck brass. Did have to seat a deeper OAL though

I’m using RCBS dies and a Redding micrometer seating die fwiw







Sent from my iPhone using Tapatalk

[jpgm]

Thanks for the reply.

jpgm

[signal4l]

There was a threat about this a while ago. Brass cased/plastic dummy rounds we're getting stuck in the Gen 5 guns. Chambers do seem to be cut shorter than Gen 3, 4

[hotrodder636]

I have not had issues with reloads in my G34/5

[jsbhike]

May be a random dud. A buddy got a 2000-2005 Glock 26 that I am reasonably sure was short chambered...would frequently stop just short of locking up.

Tried it with different magazines and at least 1/2 dozen different brass case ball and jhp loads that were reliable in my G19 and other 9mm pistols we had at the time.

He sent it back to Glock and they allegedly ran 50 rds of CCI Blazer through it without a hitch. Got it back and same deal with random failures to fully lock up.

[elde]

Appears to be a "feature" of the Marksman Barrel.

[jpgm]

Thanks for all the reply's. I will look more closely this week. I'll post back here if I discover anything.

jpgm

[MadAngler1]

I thought the Marksmen barrels were a little tighter than Gen 3/4 barrels?

[elde]

I thought the Marksmen barrels were a little tighter than Gen 3/4 barrels?

Yup, including the chamber as noted in post #4.