G&R Tactical
Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11

Thread: Issues press checking and mags dropping free on MWS

  1. #11
    Join Date
    Nov 2010
    Posts
    137
    Feedback Score
    6 (100%)
    Thanks for responses. All excellent ideas. Tried seating a round in the chamber and dropping the mag then press checking. Still had difficulty so it’s not the bolt hanging up on the mag or any other rounds in the mag. Actually never cleaned the internals of the rifle. Only lubed and shot it. Suspected chamber dirtiness might be playing a role. Will try adjusting mag catch, cleaning out the chamber and report back.

    So I just gave it a good scrubbing. Its got dual extractors so it must be the newer model. Fitting the pin into the extractor is a lot more difficult than I remember. After fighting with it for 20 minutes I knelt on my extractor to get enough pressure on it to finally fully insert the pin. Wish I was kidding.

    Still had issues with press checking. Seated a round and extracted, there are visible lines on the bullet once extracted so I assume thats from the lands.

    Am I incorrect? Is this normal?

    Thanks!
    Last edited by Quinn; 09-28-18 at 19:53.
    "Guns attract retards like moths to a porch light."-markm

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •