With barrels less than 14.5", I use full-size cans (SOCOM556-RC2); with 14.5" and longer, I use the -MINI2. Reason being that the mini cans are known not to be hearing safe on the shorter barrels.
|
||||||||||||||||||||||||||||||||||||||
With barrels less than 14.5", I use full-size cans (SOCOM556-RC2); with 14.5" and longer, I use the -MINI2. Reason being that the mini cans are known not to be hearing safe on the shorter barrels.
If a long barrel with a short can is as quiet as a short barrel with a long can but with better velocity, why bother with a short barrel at all?
A short barrel with a short can may not be hearing safe but it's much hearing safer than a long barrel without any can at all and handier than than a long barrel with a short can.
Is a full length can on a short barrel actually "hearing safe"? Is it much quieter than if a short can were used? If so, is it enough to give up the handiness of the shorter length? Personally, I see no reason to use full sized cans on my shorty ARs.
Last edited by MistWolf; 12-29-18 at 14:30.
INSIDE PLAN OF BOX
- ROAD-RUNNER LIFTS GLASS OF WATER- PULLING UP MATCH
- MATCH SCRATCHES ON MATCH-BOX
- MATCH LIGHTS FUSE TO TNT
- BOOM!
- HA-HA!!
-WILE E. COYOTE, AUTHOR OF "EVERYTHING I NEEDED TO KNOW IN LIFE, I LEARNED FROM GOLDBERG & MURPHY"
I am American
heres a good 14.5" barrel op, since colt socoms are harder to find/expensive
https://www.rainierarms.com/rainier-...id-gas-system/
Silver solder is an option for easier removal I believe. I wouldn’t necessarily cut the barrel down unless you’re dead set on wanting that inch and a half difference. But again as stated above, whatever you do make sure you use a solid Smith.
Sent from my iPhone using Tapatalk
Bookmarks