Hi everyone, just received my two troy alpha rails.. one thing im wondering, are the screws once tightened supposed to make force the barrel??? what kind of mounting system is that?????
Hi everyone, just received my two troy alpha rails.. one thing im wondering, are the screws once tightened supposed to make force the barrel??? what kind of mounting system is that?????
Evidently. Interesting design.
https://www.youtube.com/watch?v=T1ow_hdtanE
I've used two Alpha rails in the past, and I find them to be a great value for money. Once the screws are tightened the rail locks up nice and tight to the barrel nut. I would pay careful attention to the mounting instructions, especially any torque spec they may include in them. If they don't include any torque specs in the installation instructions, I would contact Troy and ask them what they recommend. And no, the screws don't apply any force on the barrel, as the mounting shims interface with the barrel nut.
I just put one on an SPR build, yes, it attaches to the standard barrel nut. It seems pretty solid. Only 241 rnds through the gun so far, carried some...no problems with it yet.
Not at all hard to put on, either. Got it all torn back down for painting at the moment.
What does “make force the barrel” mean?????
The kind of mounting system it is is a good mounting system. I’ve used several on builds, Alpha’s Troy VTAC’s (and others) and I’ve never had a rail come loose when mounted properly. My one recommendation (with just about any tail) would be to use a mount to bridge the rail and upper to get the rail perfectly aligned with the upper before tightening/torquing the screws. After that - you’re set.
Sent from my iPhone using Tapatalk
Last edited by RobertTheTexan; 01-02-19 at 05:02.
"Texas has yet to learn submission to any oppression, come from what source it may."
~ Sam Houston
“The liberties of our country, the freedom of our civil constitution, are worth defending against all hazards: And it is our duty to defend them against all attacks.”
~ Sam Adams
Are you talking about the rail clamping onto the standard barrel nut or are you referring to the add-on 1913 rail sections?
yes im speaking of the clamping system for the standard barrel nut.
The screws should be squeezing the clamps and the rail on to the barrel nut. If the screws are contacting the barrel they aren't going to be snugging the rail down.
Been awhile since I have installed mine, but not thinking that Is possible based on the screw length. Is the barrel oversized in the chamber area? Got pics?
When the screws are tightened they pull the clamping tabs towards the outside of the handguard, pinching the barrel nut between the inner edge of the handguard and the tab. Once the rail is installed, neither the locking tabs nor the screws they mount with will be contacting the barrel (the screws are not long enough themselves, and they pull the tabs out of contact with the barrel).
These aren't my pics, but they do an ok job of illustrating what everyone is trying to explain to you. The first shows how the tabs are installed on the rail:
The second shows a barrel nut installed into the rail with the tabs fully tightened. Note there is nothing extending into the center of the barrel nut in the space that would be occupied by the barrel:
Bookmarks