Well I picked up a MARS when they went on sale. Iowa made. Same thing with not dropping old g2 Pmags
Well I picked up a MARS when they went on sale. Iowa made. Same thing with not dropping old g2 Pmags
"A flute without holes, is not a flute. A donut without a hole, is a Danish." - Ty Webb
what about gen 3?
I have two LMT lowers; the older one works with everything, the newer one doesn't like G1 or 2 Pmags. Gen 3 are just fine as are GI and my new favorite Lancer. The mag well is just to tight. So the older one gets my older mags and the newer one get the most recent mags. I don't really like it but who doesn't need more magazines anyway??
Both my LMTs drop everything but my circa 2009-2011 G2 Pmags...with the exception a few. I have three Colts that drop everything.
I honestly think it’s BS that LMT defends building to spec when Colt doesn’t have the problem. Colt is the spec despite what may be written on a paper somewhere.
My main reason for asking is 1) I have 10 G2’s that I know have to segregate from my other 40 magazines. 2)G2’s are on sale for $7.99 shipped and I would love to stock up in them.
"A flute without holes, is not a flute. A donut without a hole, is a Danish." - Ty Webb
I’ve been half tempted to buy a couple newly manufactured Gen 2 Pmags to see if it’s the old mags. I have a hard time believing LMT wouldn’t try every mag
"A flute without holes, is not a flute. A donut without a hole, is a Danish." - Ty Webb
Again: Some lowers that are within mil spec, from a variety of different manufacturers, could be less than perfectly drop free with the Gen2.
You should research the issue, because a thread with bad info can pop up on google searches forever.
"The GEN M3 updates addressed a few concerns from the GEN M2...it actually drops free from most smaller mag wells better..."
https://www.m4carbine.net/showthread...59#post2002059
Magazines should be no wider than 0.888", and no longer than 2.383", not including the spine.
The magazine well should be no narrower than 0.898" and no shorter than 2.398".
All of my PMAGs run around 0.890" wide....
Last edited by lysander; 12-12-19 at 19:24.
Bookmarks